| 1. | Anode carbon for aluminium electrolysis
铝电解用预焙阳极 |
| 2. | Guide for sampling plan and core sampling of prebaked anodes used in aluminum production
铝生产中预焙阳极的取样方案和芯取样指南 |
| 3. | Technique code for retrofitting soderberg cell into prebaked anode cell in aluminium smelters
自焙阳极铝电解槽预焙化改造技术规范 |
| 4. | Effects of preheating and start - up procedure on pot - life of prebaked anode aluminum reduction cell
焙烧启动方法对预焙铝电解槽槽寿命的影响 |
| 5. | Carbonaceous materials used in the production of aluminium - sampling methods - part 3 : prebaked blocks
铝用炭素材料取样方法.第3部分:预焙阳极 |
| 6. | Standard guide for sampling plan and core sampling for prebaked anodes used in aluminum production
铝生产用预焙阳极的取样计划和芯取样的标准指南 |
| 7. | Failure of pre - baking al electrolytic cells under modern technical conditions causes and solutions
现代工艺条件下预焙铝电解槽破损原因及解决对策 |
| 8. | The size of baking the positive pole over a slow fire in advance allows the deviation to accord with the following regulations
预焙阳极的尺寸允许偏差应符合以下规定： a长度，不大于0 . 1 % |
| 9. | Aluminium electrlysis by means of low molecular ratio electrolyte is an important mark for centre - worked prebake cell at present
摘要采用低分子比电解质进行铝电解生产是现代中间下料预焙槽的重要标志。 |
| 10. | Aluminium cell test for energy balance and its calculation method - five - point feed current and six - point feed current prebaked anode aluminium cell
铝电解槽能量平衡测试与计算方法五点进电和六点进电预焙阳极铝电解槽 |
