| 1. | These software controls are used instead of request to send and clear to send hardware controls
使用这些软件控制，而不是使用请求发送( rts )和清除发送( cts )硬件控制。 |
| 2. | The hardware control circuit , software algorithm and the detailed programming list are also porvided in the paper
文中给出了具体的硬件控制电路、软件算法及详尽的程序清单。 |
| 3. | Based on the analyses of the gprs module control method , the corresponding hardware control circuit is designed in this paper
本文通过对gprs模块控制方法的探讨和分析,设计了其相应的硬件控制电路。 |
| 4. | Since the information wiring has the embedded software , it gets the name . the software embedded the hardware can control most of the hardware
嵌入式软件是嵌入到硬件中的软件，几乎所有的硬件控制均可通过它们来实现。 |
| 5. | Based on clarified the requirements of the functions , the configuration and the method to realization of the hardware control system are provided
在分析拉弯机硬件功能要求的基础上，给出了硬件控制系统体系结构和具体实现方法。 |
| 6. | A distributing hardware control system of the stretch - bending machine is designed by combining the advanced industry control computer and plc ( programmable logic controller )
采用先进的工业控制计算机与plc相结合的方式设计了分布式拉弯机硬件控制系统。 |
| 7. | Based on this project , a hardware control system of scr co _ 2 gas shield arc welding base on microprocessor msp430f449 was designed , and debugging had been completed
在此基础上,设计了以单片机msp430f449为核心的晶闸管co _ 2焊机的硬件控制系统,并且进行了调试。 |
| 8. | Deploying the new micro - power microprocessor as the controlling center simplifies and modularizes the circuit , measures and stores data independently as well as
运用新型的微功耗单片机作为硬件控制中心，使电路形式简单化、模块化，并能独立于掌上电脑进行单独测量与数据的保存。 |
| 9. | Finally , two novel control schemes , exciting voltage control and full conducted current chopping control , are discussed in detailed and proved by tests of srg prototype system
在理论分析的基础上，完成了基于dsp控制和全硬件控制的开关磁阻发电系统控制电路，并且进行了原理样机实验。 |
| 10. | This thesis mainly studies the ultra - low speed tracking and servo system : system composition , servo motor design , steering control electronics , and control software design
本文主要研究了超低速跟踪伺服系统的组成方案、伺服电机的选型设计、系统硬件控制电路设计和系统控制软件设计。 |
