| 1. | After the selection is made, the designer modifies his system digital circuit requirements to match the characteristics of the selected logic family .
选择好类型之后，设计人应该修改对系统数字电路的要求，以适应所选之逻辑电路参数。 |
| 2. | Study on the parameter matching of power circuit for ac servo systems
交流伺服系统主电路参数的研究 |
| 3. | Circuit parameter measurement
电路参数测量 |
| 4. | A novel parameter calculation method for asynchronous motor ' s equivalence circuit
异步电机等值电路参数计算的一种新方法 |
| 5. | Generation of polynomial response surface models for sizing of an analog ic
利用正多项式响应曲面模型实现模拟电路参数自动生成 |
| 6. | Variations in helical slow - wave circuit parameters and traveling wave tube characteristics
螺旋慢波电路参数变化对行波管特性的影响 |
| 7. | Also , the calculation of the main circuit parameters of the shunt - apf has been developed
本文同时给出了有源电力虑波器主电路参数选取原则。 |
| 8. | In addition , the appropriate parameters of snubber circuits and dead - times for igbt were worked out
另外还确定了igbt的缓冲电路参数、死区时间参数等。 |
| 9. | Experimental study on circuit parameters and breakdown properties of water switch under pulsed voltage
脉冲电压下的自击穿水介质开关击穿特性和电路参数实验研究 |
| 10. | - ii - finally , the paper calculates both main and control circuits ? parameters ~ n detail , and presents the process of flyhack design
论文最后详细计算了主电路和控制电路参数，以及反激变换器的设计过程。 |
