| 1. | If the compliances are not equal in the three orthogonal directions, it is anisoelastic .
如果在三个垂直方向的弹性变形率并不相等，即它是不等弹性的。 |
| 2. | Probing into residual deformation rate and hydraulic test of volume of gas bottle
气瓶容积残余变形率及水压试验探讨 |
| 3. | When ignoring the influence of deformation , the constitutive relation can be reduced to that of jaumann derivative
当忽略变形率的影响时，欧拉表述的大变形固结本构方程可退化为通常的jaumann率形式。 |
| 4. | The results show that the bonding is good when the temperature , two passes deformation ratio of rolling are 1 250 c , 50 % respectively
结果表明；轧制温度为1250c 、两道次的轧制变形率为50 %时，界面结合较好。 |
| 5. | Abstract : in this paper , the generalized variational principle of ela stic and plastic problem with finite displacement is derived by means of semi - in verse method
文摘:利用半反推法，导出了弹塑性有限变形率形式的广义变分原理 |
| 6. | Deformation of diffusion bonded parts was correlated with pressure application . m ethod o f controlling deformation and obtaining non - deformation bonding was proposed
针对实际构件，深入分析了加压方式和变形率的关系，并提出了控制变形量得到无变形接头的方法。 |
| 7. | Epe compression and transformation rate are the lowest in same type of material . suitable for repeatedly crash buffering . long distance transport of precise equipment , electronic and computer
Epe压缩变形率,为同类包材中最低体积最小,适合多次撞击缓冲保护,精密仪器,电脑电子系列长途产品运输。 |
| 8. | Vacuum diffusion welding of refractory steel to heat resistant alloy was investigated in this paper . the effect of welding parameters on the deformation ratio of joints was examined
针对耐热合金与耐热钢的真空感应扩散焊，研究了扩散焊连接工艺参数对接头变形率的影响、接头变形率与接头性能的关系以及不同接头变形率的微观形态。 |
| 9. | Methods of test for flexible cellular materials - method 17 - determination of tear strength of flexible cellular material with an integral skin - method 18 - determination of compression set under humid conditions
软质微孔材料试验方法.第7部分:方法17 :用整皮测定软质微孔材料撕裂强度方法.方法18 :在潮湿条件下测定加压变形率方法 |
| 10. | The influences of the temperature , speed and deformation ratio of rolling during producing composite stainless steel band by inversion casting on the bonding between the mother band and solidified layer were investigated
摘要针对用反向凝固法生?不?钢复合带的工艺，研究了轧制温度、轧制速度及轧制变形率对母带与凝固层间结合的影响。 |
